Model: INT-2704
Brand: Chineese
I2C Interface 1602 2004 LCD Adapter Plate for Arduino has PCF8574 I2C chip that converts I2C serial data to parallell data for the LCD display. It can be connected to a standard HD44780 compatible 16x2 or 20x4 Character Display Module that supports 4 bit mode. In general, LCD connection with A..
Rs 155.00
Hot
Model: ROB-2898
Brand: Chineese
MP1584 DC-DC 3A Step Down Module converts input voltage between 4.5V and 28V into a smaller voltage between 0.8V and 18V, capable of driving a 3A load with excellent line and load regulation.This makes the fully compatible with setups from 2-6s. Simply turn the small screw to adjust the voltage.
..
Rs 45.00
Model: INT-2573
The USB Blaster Download Cable interfaces a USB port on a host computer to an Altera® FPGA mounted on a printed circuit board. The cable sends configuration data from the PC to a standard 10-pin header connected to the FPGA. You can use the USB Blaster cable to iteratively download configuration dat..
Rs 1,399.00
Model: INT-2571
Brand: rhydoLABZ
A lot of devices out can communicate over RS232 your new laptop isn’t one of them! Not just with laptops, many other devices often demands converters for RS232 serial. This USB to RS232 converter is probably the best solution on such situations.This, high quality, low cost, small, and easy to use, c..
Rs 299.00
Model: INT-2568
Brand: Wiznet
WIZ550S2E is the serial to Ethernet module using W5500 & Cortex-M0 MCU. WIZ550SE is the protocol converter that transmits the data sent by serial equipment as TCP/IP data type, and converts back the TCP/IP data received through the network into serial data to transmit back to the equipment.If yo..
Rs 2,099.00
Model: INT-2570
Brand: Wiznet
ioShield-A allows an Arduino board to connect to the Internet. It is based on the WIZ550io network module which uses WIZnet W5500 ethernet chip (W5500 Datasheet). The WIZnet W5500 provides a network (TCP/IP) stack capable of both TCP and UDP. It supports up to eight simultaneous socket connect..
Rs 1,926.00
Model: INT-2569
Brand: Wiznet
WIZ550web is an embedded Web server module based on WIZnet W5500 hardwired TCP/IP chip. User can control & monitor the 16-configurable digital I/O and 4-ADC inputs on module via web pages. WIZnet provides firmware & web page examples for user to customize their own objective. &nbs..
Rs 2,899.00
Model: INT-2562
Brand: rhydoLABZ
The CP2102 basic board made by rhydoLABZ for the USB to serial conversion. This is a great little tool for embedded systems that require a serial connection to a computer. This breakout also allows you to connect the TX/RX pins of your favorite microcontroller or serial application to the ..
Rs 399.00
Model: INT-2564
Brand: rhydoLABZ
This is the CP21202 Breakout Board. This is a great little tool for embedded systems that require a serial connection to a computer. The board can simply attach to a USB bus via a mini USB connector and will appear as a standard COM port.
Thes CP2102 doesn’t require any external oscillator, it ha..
Rs 379.00
Model: INT-2563
Brand: rhydoLABZ
This PC Keyboard Decoder is able to accept standard PC keyboard and decode the data into serial ASCII at 9600bps output. PC’s keyboards available nowadays are readily available at cheap cost and can be a cheap alternate to a keyboard on a microcontroller development system with lots of available key..
Rs 299.00
Model: INT-2558
Brand: Sparkfun - USA
The SparkFun FTDI SmartBasic is a variation on our classic FTDI Basic board which allows you to connect a second device to the hardware serial port on an Arduino Pro, Pro Mini, or other USB-less board without compromising the ability to bootload code from the Arduino IDE. The FTDI SmartBasic hardwar..
Rs 1,099.00
Model: INT-2556
Brand: 4D Systems
The microUSB Programming Adapter (uUSB-PA5) is a USB to Serial-TTL UART bridge converter which is simple, cost effective, very small and easy to use.It uses a mini-B type USB connector to connect to your PC and is based on the FTDI FT232RQ USB to Serial Bridge IC from FTDI Chip.
It provides t..
Rs 2,269.00
Model: INT-2554
Brand: Dorji
DACx3 series USB converter boards are designed for testing DRF4432D20I series of modules. DAC03 board is USB-to-TTL converter board. DAC13 is USB-to-RS232 converter board and DAC23 is USB-to-RS485 converter board. Users need to install USB driver first before using them. The driver can be downloaded..
Rs 699.00
Model: INT-2513
Brand: Pololu - USA
The D24V5Fx family of buck (step-down) voltage regulators generates lower output voltages from input voltages as high as 36 V. They are switching regulators (also called switched-mode power supplies (SMPS) or DC-to-DC converters) and have a typical efficiency between 80% to 93%, which is much more e..
Rs 399.00
Model: DEV-2487
Brand: PICAXE
This kit allows the PICAXE programmer to be easily connected
to breadboard making prototyping with PICAXE microcontrollers even
cheaper and faster.The adapter connects a 3.5mm jack socket to pins that are then inserted into the breadboard. This can make a far more reliable circuit connection tha..
Rs 269.00