Description: The WiFly GSX (RN-131C) module is a
complete ultra low power embedded TCP/IP solution. The WiFly GSX module
is a stand alone, embedded wireless 802.11b/g networking module. The
combination of ultra low power and the ability to wake up, connect to a
wireless network, send data and re..
The Arduino WiFi Shield made by Arduino -Italy allows an Arduino board to connect to the internet using the 802.11 wireless specification (WiFi). It is based on the HDG104 Wireless LAN 802.11b/g System in-Package. An Atmega 32UC3 provides a network (IP) stack capable of both TCP and UDP. Use the WiF..
Description: It is a evaluation board from WIZNET for testing wizFi220 wifi module .Since the Wifi module is SMD type, it will be difficult to develop a prototype , here this board come in to action. This EVB kit includes all the accesories including one WizFi Module soldered in breakout. The W..
Description: It is a evaluation board from WIZNET for testing wizFi210 wifi module .Since the Wifi module is SMD type, it will be difficult to develop a prototype , here this board come in to action. This EVB kit includes all the accesories including one WizFi Module soldered in breakout.   Â..
Description: The WizFi630 is an High Performance 802.11b/g/n serial to WiFi module. The module provides serial UART interface which enables connection to any embedded design utilizing and 8/16/32-bit microcontroller via simple commands. The module supports Physical link rate up to 150Mbps, and is ..
Description: The WizFi220_CA is an ultra low power serial to WiFi module with power amplifier and onboard Chip Antenna. The module provides serial UART interface which enables connection to any embedded design utilizing and 8/16/32-bit microcontroller via simple commands. The module supports data ra..
Description: The WizFi210_CA is an ultra low power serial to WiFi module with Chip antenna. The module provides serial UART interface which enables connection to any embedded design utilizing and 8/16/32-bit microcontroller via simple commands. The module supports data rates up to 11 Mbps, and is co..
Description: The WizFi220_CON is an ultra low power serial to WiFi module with power amplifier. The module provides serial UART interface which enables connection to any embedded design utilizing and 8/16/32-bit microcontroller via simple commands. The module supports data rates up to 11 Mbps, and i..
Description: The WizFi210_CON is an ultra low power serial to WiFi module. The module provides serial UART interface which enables connection to any embedded design utilizing and 8/16/32-bit microcontroller via simple commands. The module supports data rates up to 11 Mbps, and is compliant with 802...
Description: This IEEE 802.11 b/g Wireless LAN Module is the WiFi module used on LS6410 S3C6410 development board. Compliance with the IEEE 802.11b/g standard, it uses Direct Sequence Spread Spectrum (DSSS), Orthogonal Frequency Division Multiplexing (OFDM), DBPSK, DQPSK, CCK and QAM baseband modula..
Description: LS-UART-WiFi is a WLAN Module with UART serial interface by LinkSprite. This high quality SOC chip based solution is very much cost-effective and stable. It works with built-in WiFi protocol stack and serial transfer protocol. It provides simple four-wire connection interface (5V, GND, ..
Description: The WiFly Shield equips your Arduino the ability to connect to 802.11b/g wireless networks. The featured components of the shield are a Roving Network's RN-131C wireless module and an SC16IS750 SPI-to-UART chip. The SPI-to-UART bridge is used to allow for faster transmission speed and t..