ScanaPLUS: 9-Channels, 100MHz Logic Analyzer

  Thanks to its configurable and fully protected input stage, ScanaPLUS can be directly connected to RS232, to CAN or RS485 differential lines, or to tiny 1.2V logic signals! Plus, a logic analyzer with 9 channels, will allow you to work with 8-bit buses, having a 9th channel left for a synchronization signal.

  Worry no more about maximum capture time or transfer speed from device to computer. ScanaPLUS relies on a proprietary FPGA based compression and streaming algorithm, that will capture signals for as long as your computer can take!

• 100 MSPS (Million samples per second).
• Accuracy: ± 10 ns
• Maximum capture time: 1000 seconds *
• Number of channels: 9.
• Dimensions: 73 x 46 x 17 mm (2.87 x 1.81 x 0.67 inches)
• Weight: 59 gm (2.08 oz)
• Maximum capture time of 1000 seconds is only limited by software capabilities, it may be increased via future software updates

• Number of adjustable logic threshold groups: 2
• Adjustable logic levels for each group: 1.2V, 1.5V, 1.8V, 2.8V, 3.3V to 5V
• Number of integrated receivers for RS232 bus: 5
• Number of integrated receivers for LIN bus: 5
• Number of integrated differential lines receivers: 2 (can used for CAN, RS485, etc.)
• Activity LED integrated to ScanaPLUS device quickly indicates logic change on any line
• Input operating range ± 35V
• Absolute maximum input range ± 50V
• Input impedance 100KO || 5pF

• Configurable trigger event types: Rising edge, Falling edge, Logic level, Pulse width
• Multichannel trigger support: Yes
• Number of cascaded events to trigger: Unlimited number of events

• Compatible with ScanaStudio V2.0 and above. (Multi-workspace, features rich environment used for device configuration, signal visualization and protocol decoding)

• • Windows: Windows XP, Vista, and 7 (32 or 64 bit)
  • Linux: Recent Ubuntu (32 or 64 bit)

• Minimum system requirements USB 2.0 Port, 512MBytes of RAM

  ScanaPLUS will allow you to capture logic transition whose logic levels are as low as 1.2v and all the way up to 5V logic levels. While configuring the exact threshold voltage is not critical for most application, it will give you much better accuracy when measuring  high frequency signals (above 1MHz).

 Do you need to capture 1.8 v signals on some pins, while capturing 5V signals on others? No problem, with ScanaPLUS you can define 2 different logic thresholds for two groups of inputs!

    That’s a detail that can save a big deal of time. If you ever see flat lines on the screen instead of the signals you’re expecting, you may wonder if the problem is with your source code, or the trigger configuration. Sometimes you are just wondering: “is there any activity on the lines at all?” ScanaPLUS’ software independent activity LED will answer your questions by blinking whenever any activity is detected on the logic analyzer lines.

• Analysis and debugging of digital electronics circuits
• Serial protocol decoding and analysis (UART, I2C, SPI, CAN, 1-WIRE, LIN, Manchester,…)
• Capturing signals over RS485 and CAN bus differential lines directly
• Capturing signals over LIN and RS232 data lines
• Capturing of high frequency / low voltage digital signals (down to 1.2V)
• Working risk-free where 12V and 24V lines are present.
• Decoding and debugging of custom /proprietary protocols
• Capturing of long data sequences (tested up to 10 minutes)
• Precise frequency and timing measurements
• Analysis of 8 bit data buses