ESP32S NodeMCU WiFi/Bluetooth Development Board- CP2102 (30 PIN)

Description : The NodeMCU ESP32 Development board is equipped with a powerful ESP-WROOM-32 module, making it a versatile WiFi and Bluetooth solution for a wide range of applications. This board is used with 2.4GHz dual-mode WiFi and Bluetooth chips with 40nm low-power technology. There are two CPU cores that can be individually controlled, and the CPU clock frequency is adjustable from 80 MHz to 240 MHz.

ESP32 integrates a rich set of peripherals, ranging from capacitive touch sensors, Hall sensors, SD card interface, Ethernet, high-speed SPI, UART, I2S and I2C. ESP32 is already integrated antenna and RF, power amplifier, low-noise amplifiers, filters, and power management mode. With power consumption under 5µA, it's perfect for wearable electronics and battery-powered applications.

This board fits directly onto a breadboard and let you connect sensors, relays, and other external modules through its input output pins. It can be directly programmed using the Arduino IDE. The ESP32 Development Board contains all the external circuits required to use the ESP32 IC, including the USB-UART bridge, reset and boot-mode buttons, LDO regulator and a micro-USB connector. With the NodeMCU ESP32 CP2102, you can explore endless possibilities in IoT, home automation, robotics, and more.

• Integrated ESP-WROOM-32 and CP2102 driver
• Hybrid WiFi & Bluetooth
• High level of integration
• Ultra low power management
• On-board PCB antenna
• High degree of fusion
• Supporting Lua program, easily to develop
• WIFI     :  2.4GHz Dual-Mode
• Protocol Support    :  LWIP, Freertos
• Supporting three modes  :  AP, STA, and AP+STA

• Operating voltage (v)       :     3.0V – 3.6V
• Clock Frequency (MHz)     :     80 MHz – 240MHz
• Operating current (mA)     :    80 mA
• SRAM Memory (KB)    :    520 KB 
• Data Rate (Mbps)       :    150Mbps
• Flash memory (MB)    :     4MB
• Number of Pin   : 30
• Dimension    :   28mm x 50mm x 14 mm

• ESP32 WROOM-32 Datasheet