This is newest revision of rhydoLABZ make USB to Serial Converter (FT232RL Breakout) board INT-1202. It is a compact and ready to use board which performs USB to Serial TTL (5V and 3V3) and vice versa conversion. The board holds an FT232RL USB UART IC for conversion. This module process an easiest interfacing of USB with microcontroller application boards. The unit is powered through USB and does not require external Power.The module Can be used for interfacing 5V and 3V3 application (ARM ect.) board to PC USB port. The Selected interfacing voltage is also available at RMC connector for powering ( <50ma only) interfacing sensors ect.All FT232RL Pins are available at bergstrip pin out for advanced users.
Check out these really well done tutorials on bit-banging SPI with the FT232. Nice work Michael!
USB to Serial Converter Features
USB 2.0 Full Speed compatible.
Compact High Quality Two layer PTH PCB
Professional EMI/RFI Complaint PCB Layout Design for Noise Reduction
On Board FT232R USB UART IC
Jumper selection for Interfacing Voltafe Selection ( 3V3/5V)
Powered via USB
On Board Power LED Indicator
Supports data transfer from 300 Baud to 1 Mega Baud
Single chip USB to asynchronous serial data transfer interface.
Entire USB protocol handled on the chip. No USB specific firmware programming required.
Data transfer rates from 300 baud to 3 Mbaud (RS422, RS485, RS232 ) at TTL levels.
128 byte receive buffer and 256 byte transmit buffer utilising buffer smoothing technology to allow for high data throughput.
FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
Unique USB FTDIChip-ID™ feature.
Configurable CBUS I/O pins.
LEDs for Transmit and receive signals.
UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity
Synchronous and asynchronous bit bang interface options with RD# and WR# strobes.
Device supplied pre-programmed with unique USB serial number
Integrated level converter on UART and CBUS for interfacing to between +1.8V and +5V logic.
Configurable I/O pin output drive strength
UART signal inversion option.
Low operating and USB suspend current.
Low USB bandwidth consumption.
UHCI/OHCI/EHCI host controller compatible.
All I/O pin available at bergstrip
Internal EEPROM for device ID and Product Description strings
Royalty-Free Driver support for Windows, Linux, and Mac OSX
Downloads:
