USB to Serial Converter (5V/3V3) - rhydoLABZ

Features 

•  USB 2.0 Full Speed compatible.
• Compact High Quality Two layer PTH PCB 
• Professional EMI/RFI Complaint PCB Layout Design for Noise Reduction
• On Board FT232R USB UART IC
• Jumper selection for Interfacing Voltage Selection ( 3V3/5V)
• Powered via USB
• On Board Power LED Indicator
• Supports data transfer from 300 Baud to 1 Mega Baud 
• Single chip USB to asynchronous serial data transfer interface.
• Entire USB protocol handled on the chip. No USB specific firmware programming required.
• Data transfer rates from 300 baud to 3 Mbaud (RS422, RS485, RS232 ) at TTL levels.
• 128 byte receive buffer and 256 byte transmit buffer utilising buffer smoothing technology to allow for high data throughput.
• FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
• Unique USB FTDIChip-ID™ feature.
• Configurable CBUS I/O pins.
• LEDs for Transmit and receive signals.
• UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity
• Synchronous and asynchronous bit bang interface options with RD# and WR# strobes.
• Device supplied pre-programmed with unique USB serial number
• Integrated level converter on UART and CBUS for interfacing to between +1.8V and +5V logic.
• Configurable I/O pin output drive strength
• UART signal inversion option.
• Low operating and USB suspend current.
• Low USB bandwidth consumption.
• UHCI/OHCI/EHCI host controller compatible.
• All I/O pin available at bergstrip
• Internal EEPROM for device ID and Product Description strings
• Royalty-Free Driver support for Windows, Linux, and Mac OSX

Package includes:

• 1 x USB to Serial Converter (5V/3V3)
• 1 x 4 pin RMC Connector with Cable

Downloads & Downloads:

• Schematic
• FT232RL IC Datasheet
• FTClean (for removing extraneous/old ports)
• Drivers
• FTDI Virtual Com Port(VCP) driver Installation-wiki