Servo Driver HAT (B) for Raspberry Pi, 16-Channel, 12-bit, I2C

Needless to say, the Raspberry Pi is powerful enough in most cases, yet it's not that good at providing precise PWM output. You may have tried to control a robotic arm or a hexapod walker by using the Pi, but finally get frustrated due to the limited number of PWM outputs and the jittering servo. Now you get a new option to bring your ideas to life, here you can go with this Servo Driver HAT.

Features:

• Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
• I2C controlled, using only 2 pins
• Up to 16-Channel servo/PWM outputs, 12-bit resolution for each channel (4096 scales)
• Integrates 5V regulator, up to 3A output current, can be powered from battery through VIN terminal
• Standard servo interface, supports common used servo such as SG90, MG90S, MG996R, etc.
• Reserved I2C control pins, allows to work with other control boards
• Comes with development resources and manual (examples in python like Bluetooth/WiFi remote control)

Specifications:
 

• Power supply: 5V (Pi connector) OR 6V~12V (VIN terminal)
• Servo voltage: 5V
• Logic voltage: 3.3V
• Driver: PCA9685
• Control interface: I2C
• Dimension: 65mm x 30mm
• Mounting hole size: 3.0mm

Supported Servo:
 

This HAT can be used to drive servos such as:

• SG90 Servo
• MG90S Servo
• MG996R Servo

Package Includes:
 

• 1x Servo Driver HAT
• 1x RPi screws pack (2pcs)

Developmemt Resources:
 

• Product page
• Waveshare wiki
• Schematic
• User Manual
• Datasheets:
  • PCA96
  • MP1584
  • RT9193