ProtoShield Kit for Arduino - Sparkfun USA

Riding on the waves of the very popular Arduino USB board is this small prototyping shield. The ProtoShield mates with the Arduino USB board and gives the user a small soldering area, two general LEDs, access to a BlueSMiRF socket, a general pushbutton switch, and most important of all - the Arduino reset switch is brought to the top level. A ProtoShield quickstart guide is available!

This comes in kit form and must be soldered together by the end user.All soldering is through-hole (relatively easy) but always check your component orientation before soldering!

Note: The SparkFun ProtoShield Kit does not include the holes for the Uno R3 SDA and SCL.

Features:

• All Arduino pins are brought to the top level
• 5V, GND, and Vin pins are exposed as well
• BlueSMiRF socket for wireless communication between Arduinos
• 2 general use LEDs
• 1 general use button
• Reset button brought to top level

Package Includes:

• 1 x ProtoShield bare PCB
• 2 x Stackable Headers 6-pin
• 2 x Stackable Headers 8-pin
• 2 x 5mm Basic Yellow LEDs
• 2 x 330 Ohm resistors
• 1 x 10k resistor
• 2 x Momentary push buttons
• 2 x 0.1uF Ceramic Capacitors

Documents & Downloads:

• Arduino ProtoShield Kit Schematic
• Arduino ProtoShield Kit Eagle Files
• Arduino Home Page
• GitHub (Design Files)
• Product Page