ISO3080DWR Isolated 5-V/ Rs-485 Transceivers IC(SMD)

The ISO3080 IC is an isolated full- duplex differential line drivers and receivers. These are ideal for long transmission lines because the ground loop is broken to allow for a much larger common-mode voltage range. The symmetrical isolation barrier of the device is tested to provide 2500 VRMS of isolation for 60s per UL 1577 between the bus-line transceiver and the logic-level interface.

Any cabled I/O can be subjected to electrical noise transients from various sources. These noise transients can cause damage to the transceiver and/or nearby sensitive circuitry if they are of sufficient magnitude and duration. These isolated devices can significantly increase protection and reduce the risk of damage to expensive control circuits.

The ISO308x family consists of RS-485 transceivers commonly used for asynchronous data transmissions. Full- duplex implementation requires two signal pairs (four wires), and allows each node to transmit data on one pair while simultaneously receiving data on the other pair. To eliminate line reflections, each cable end is terminated with a termination resistor, R(T), whose value matches the characteristic impedance, Z0, of the cable. This method, known as parallel termination, allows for higher data rates over longer cable length.

Features of ISO3080DWR

• Meets or Exceeds TIA/EIA RS-485 Requirements
• Thermal Shutdown Protection
• Low Bus Capacitance – 16 pF (Typical)
• 50 kV/μs Typical Transient Immunity
• Fail-safe Receiver for Bus Open, Short, Idle
• 3.3-V Inputs are 5-V Tolerant
• Rated isolation : 4000 VPK / 2500 VRMS
• Type :Full duplex
• Data rate :200 kbps
• Operating Temperature : -40°C ~ 85°C
• Mounting Type : Surface Mount
• Package : 16-SOIC

Package includes:

• 1 x ISO3080DWR

Development resources:

• Datasheet