Description: This is a low cost MPLAB Compatible PIC programmer. The programmer will detect automatically as Pickit2 programmer by MPLAB. It can program all 5V PIC microcontrollers including the PIC16F84A, PIC16F628, PIC18F458 and PIC16F877A etc.
The PIC Programmer uses a USB port for power and connection to the computer, as opposed to the traditional serial port, eliminating the need for a separate power supply. It will automatically power the Circuit, if the target Controller is not powered. Programming can be done either via ICSP connector pins or the RJ11 connector. the pin ICSP connectors comes unsoldered withe the package, if required the ICSP connector pins can be soldered on to the board right below the RJ11 connector section.
- USB Connection (cable Included)
- Does not require external power supply
- 100% compatible with Microchip’s MPLAB IDE (Pickit2)
- Compact and handy design
- Both RJ11 connector and ICSP 6PIN Connector for programming.
Note: This programmer is not recommenmded for low voltage(3V) microcontrollers.
- 1x PIC Programmer Lite
- 1x USB cable
- 1x RJ11 cable for programming
- 1x 6PIN ICSP Connector