Description: The Ball Caster with 3/4" Metal Ball includes a black ABS housing, a blue abs/acrylic base and two #2 screw sets. The total height of this ball caster is 0.83" with no spacers. You can also adjust the height by adding the spacers. The ball caster can be mounted to a chassis by the two s..
Description: The GMPW wheel is made to match the Solarbotics GM2, GM3, GM8, and GM9 gearmotors, and it also match the Pololu plastic gearmotors. This plastic wheel is molded from ABS and has a molded-on thermoplastic silicone tire with great traction and wear characteristics. There is a 64-stripe en..
This board is a simple carrier of Allegro’s ±75A ACS709 Hall effect-based linear current sensor with overcurrent fault output, which offers a low-resistance (~1.1 mΩ) current path and electrical isolation up to 2.1 kV RMS. The sensor has optimized accuracy for currents from -37.5&nbs..
Unleash your Arduino! This shield allows you to interface Wixel wireless modules to your Arduino (and other compatible products), enabling simple wireless programming, debugging, and control using standard Arduino software. Wixel developers can also use this item as a Wixel prototyping board. ..
Description: This version of the product is packaged as a partial kit in which the surface-mounted components are already assembled. Male header pins and a DB9 connector are included, but they need to be soldered in by the user.The Serial 8-servo controller allows you to control up to eight RC servo..
The IR beacon is a compact board that is used in pairs to allow robots to locate each other. Each board has infrared emitters that shine in all directions and four IR receivers for detecting the other beacon. The IR beacons have a range of about fifteen feet indoors. This item is for a single u..
Description: This Simple Controller 18v7 makes basic control of brushed DC motors easy, with free Simple Motor Control Center software enabling quick configuration over USB. This version operates from 5.5 to 30 V and is efficient enough to deliver a continuous 7 A (>30 A peak) without a heat sink..
Description: This breakout board for Freescale’s MC33926 full H-bridge has an operating range of 5 – 28 V and can deliver almost 3 A continuously (5 A peak) to a DC motor. The MC33926 works with 3 – 5 V logic levels, supports ultrasonic (up to 20 kHz) PWM, and features current feedback, under-voltag..
Description: This 12" (30 cm) harness has an inline on/off switch, with a 0.1" 3-pin female connector on one end and both a male and a female connector on the other. This 3-wire harness can be used to add a toggle switch between any two devices that can be connected with JR style servo connec..
Description: This slick tire set contains four wheels with arched tires, each with a diameter of 31 mm (1.2") and a width of 10 mm (0.4"). These wheels are compatible with Tamiya gearbox kits with 3mm-hex shafts.
This tire set includes the following:
Four arched tires: 31 mm diameter, 10 mm w..
The Pololu Wixel is a general-purpose programmable module featuring a 2.4 GHz radio and USB. You can write your own software or load precompiled, open-source apps onto the TI CC2511F32 microcontroller at the heart of the Wixel, turning it into a wireless serial link, data logger, or whatever you nee..
This high-quality metal gearmotor is a compact (1.16" x 0.61" x 0.61") motor with an enclosed 35:1 metal gearbox. These units have a 0.275"-long, 3 mm-diameter D-shaped output shaft.
Specifications:
Gear ratio: 35:1
Free-run speed @ 6V: 460 rpm
..
Description: This 6-inch (150-mm), twisted cable has 22-AWG wires and female “JR”-style connectors on both ends, the same kind of connector commonly found on RC hobby servos. It can be used to make connections between devices with 0.1" 3-pin male headers, such as between RC servo controllers or RC r..
This 24-inch (600-mm), flat cable can be used to extend the leads of many common RC hobby servos. It has 22-AWG wires, and both the male and female cable ends are compatible with both JR- and Futaba-style connectors, allowing it to work in either system or as an adapter between systems. The cable’s ..
Description: This 12-inch (300-mm), flat cable can be used to extend the leads of many common RC hobby servos. It has 22-AWG wires, and both the male and female cable ends are compatible with both JR- and Futaba-style connectors, allowing it to work in either system or as an adapter between systems...