Model: INT-3305
Brand: Sparkfun - USA
SparkFun Serial Basic Breakout is an easy-to-use USB-to-Serial adapter based on the CH340G IC from WCH. It works with 5V and 3.3V systems and should auto install on most operating systems without the need for additional drivers. The Serial Basic uses the CH340G IC to quickly and easily convert seria..
Rs 629.00
Model: DEV-3308
Brand: Sparkfun - USA
SparkFun weather:bit is a fully loaded “carrier” board for the micro:bit that, when combined with the micro:bit, provides you with a fully functional weather station. With the weather:bit you will have access to barometric pressure, relative humidity and temperature readings. There are also connecti..
Rs 1,399.00
Model: ROB-3320
Brand: Sparkfun - USA
SparkFun Serial Controlled Motor Driver (SCMD) is a DC motor driver that’s been designed to drive small DC motors with ease. The SCMD is designed to emulate a typical register-based device in operation. It can be commanded by UART, I2C or SPI communication and it can drive a constant 1.2A load per m..
Rs 1,149.00
Model: DIS-3304
Brand: Sparkfun - USA
SparkFun Lumenati 90L is a small quarter-circle board equipped with three APA102C LEDs and a single mounting position that has been designed to give your projects an edge in their lighting capacity. The 90L board has been specifically designed to be daisy-chained with other Lumenati boards. Addition..
Rs 359.00
Model: WID-3319
Brand: Sparkfun - USA
SparkFun LiPo Charger/Booster - 5V/1A is a no-nonsense circuit for generating one amp from a Lithium Polymer battery at 5V. This LiPo charger is a very economical choice that is equipped with a simple booster circuit utilizing the PAM2401 IC, and includes protection diodes so you can run multiple ce..
Rs 1,499.00
Model: RAS-3309
Brand: Sparkfun - USA
SparkFun Pi Servo HAT allows your Raspberry Pi to control up to 16 servo motors in a straightforward and uncomplicated manner via an I2C connection. Additionally, the Pi Servo HAT adds a serial terminal connection, which will allow to bring up a Raspberry Pi without having to hook it up to a monitor..
Rs 899.00
Model: WID-3332
Brand: Sparkfun - USA
SparkFun LiPo Charger Basic - Micro-USB is used to charge charge LiPo batteries. The SparkFun LiPo Charger charge 3.7V LiPo cells at a rate of 500mA. It is designed to charge single-cell Li-Ion or Li-Polymer batteries. The board incorporates a charging circuit, status LED, connector for your battery..
Rs 799.00
Model: SEN-3325
Brand: Sparkfun - USA
Ambient Light Sensor Breakout - APDS-9301 is an I2C-compatible luminosity sensor board that converts light intensity to a digital output signal. This breakout is fairly simple and has been specifically designed with only a few ancillary passive components in addition to the ADPS-9301 IC itself. All ..
Rs 499.00
Model: DEV-3318
Brand: Sparkfun - USA
Proto Expansion Board for the Onion Omega allows to create a prototype that interfaces with Omega. This little board provides a small soldering area and 30-pin header that plugs into the Expansion Dock. The Onion Omega boards are separated into three different categories: Mainboard, Dock and Expansi..
Rs 469.00
Model: DEV-3307
Brand: Sparkfun - USA
SparkFun moto:bit is a fully loaded “carrier” board for the micro:bit that, when combined with the micro:bit, provides with a fully functional robotics platform. The moto:bit offers a simple, beginner-friendly robotics controller capable of operating a basic robotics chassis. Onboard each moto:bit a..
Rs 1,099.00
Model: ROB-3321
Brand: Sparkfun - USA
Pan/tilt bracket kit utilizes servos to move on two axes fit for camera and helping-hand applications. This particular bracket kit is the same one used in SparkFun Raspberry Pi Zero W Camera Kit to create a remote camera system for home or workplace. Everything is included to get this kit assembled,..
Rs 699.00
Model: DEV-3316
Brand: Sparkfun - USA
OLED Expansion Board for Onion Omega adds a low-power 0.96" monochrome display to Omega. With a resolution of 128×64, it is used to display text, images and even animations. This Expansion Board is very useful for displaying status information, web data and small logos. 21 characters can fit on each..
Rs 1,349.00
Model: DEV-3312
Brand: Sparkfun - USA
Omega2+ IoT computer is Onion’s top-end Linux-based WiFi development board designed to enable makers of all skill levels to build connected hardware applications. Plug the Omega, and it will boot the operating system right away, allowing to develop a favorite programming language, create web applica..
Rs 1,599.00
Model: SEN-3324
Brand: Sparkfun - USA
SparkFun Environmental Combo Breakout - CCS811/BME280 (Qwiic) takes care of all atmospheric-quality sensing needs with the popular CCS811 and BME280 ICs. This unique breakout provides a variety of environmental data, including barometric pressure, humidity, temperature, TVOCs and equivalent CO2 (or ..
Rs 3,199.00
Model: DEV-3306
Brand: Sparkfun - USA
The Teensy is a breadboard-friendly development board with loads of features in a teensy package. Each Teensy 3.6 comes pre-flashed with a bootloader so you can program it using the onboard USB connection, so no need of any external programmer. You can program for the Teensy in your favorite program..
Rs 2,999.00