Description: The shield Motor is based on the L298P, can be used to drive 2 DC motor or one 4-wire stepper and one 5v servos. The shield drives motors with digital pins D10, D11, D12, D13, and servo with digital pin D9. The Shield Motor is a full bridge double designed to drive inductive loads such as DC solenoid relays and stepper motors. It allows to drive two DC motors with board, controlling the speed and direction of each one independently.
The L298P Motor Driver Shield for Arduino features an onboard male header for an ultrasonic sensor connected to digital pins D7 & D8, female header for the Bluetooth module, servo header connected to pin D9, male headers connected to PWM pins D3, D5, D6. The buzzer on the board can be used to signal the desired situation.
Features :
- The shield drives motors with digital pins D10, D11, D12, D13, and servo with digital pin D9
- L298P drives 2 DC motors or one stepper motor
- Option for Bluetooth module Connection.
- Pin D2, D3, D5, D6, D7, D9 are not occupied by the digital interface
- It has six analog interfaces(A0,A1,A2,A3,A4,A5)
- It has indicator for forward and backward changing direction
- Onboard buzzer (D4), can set the astern alarm ringtone.
Specifications:
- Input voltage : 5V
- Working temperature : -25 + 130 Celsius
- Motor Driven Voltage : 4.8-35V (From Arduino or External Power Source).
- Motor Driven current Io : ≤2A.
- Drive Type : Dual power H-bridge driver
- supports PWM/PLL mode motor speed control using jumper to switch
Documents:
There are currently no any reviews about this product.
There are currently no any question about this product.
