CC Debugger, LPC Debuggers & Programmers

The CC Debugger is primarily used for debugging and programming the flash on CCxxxx 8051-based System-on-Chip (SoC) devices from Texas Instruments. CC Debugger also supports CCxxxx RF transceivers. In addition, CC Debugger is used for configuring the CC85xx devices with PurePath Wireless Configurator.

Specifications of CC Debugger, LPC Debuggers & Programmers :

    Performance

• Compatible with the original TI CC Debugger
• Supported OSs:Windows 2000, Windows xp sp2/sp3, Windows Vista 32bit, Windows 7 32bit
• Target voltage: 1.2V ~ 3.6V
• Capable of powering the target board from the debugger
• Operating temperature: 0~85 degree

    Supported Software

• IAR Embedded Workbench For C8051
• SmartRF Flash Programmer
• SmartRF Studio
• SmartRF Packet Sniffer
• PurePath Wireless Configurator
• Connects to PC

    Computer connection via USB interface

• Connects to target board

          Target board connection via 10-pin IDC connector (2x5 2.54mm pitch). The figure below shows the header pinout:CC Debugger header pinout

Supported Devices

    Programming and debugging the following 8051-based system-on-chips from Texas Instruments:
CC1110, CC1111
CC2430, CC2431
CC2510, CC2511
CC2530, CC2531, CC2533
CC2540, CC2541
CC2543, CC2544, CC2545
Controlling the following transceivers from SmartRF Studio:
CC1120, CC1121, CC1125, CC1175
CC1101, CC110L, CC113L, CC115L
CC2520
Configuring the CC85xx devices with PurePath Wireless Configurator:
CC8520, CC8521
CC8530, CC8531

LED Status

    OFF: The debugger has no power or there is no valid firmware on the debugger.
AMBER (BOTH LEDS ON): The debugger is powered, but there is no valid firmware.
RED LED BLINKING: The Debugger is in Boot Recovery Mode.
RED LED ON: No device detected.
GREEN LED ON: The target device has been properly detected. It is possible to start programming/debugging.

Package includes:

•     CC Debugger × 1
•     USB cable × 1
•     10-pin flat cable × 1

Resources :

• Waveshare Wiki