Menu
Your Cart

ST-LINK V2 in-circuit Debugger / Programmer for STM8 and STM32

ST-LINK V2 in-circuit Debugger / Programmer for STM8 and STM32
ST-LINK V2 in-circuit Debugger / Programmer for STM8 and STM32
ST-LINK V2 in-circuit Debugger / Programmer for STM8 and STM32
ST-LINK V2 in-circuit Debugger / Programmer for STM8 and STM32
New
ST-LINK V2 in-circuit Debugger / Programmer for STM8 and STM32
ST-LINK V2 in-circuit Debugger / Programmer for STM8 and STM32
ST-LINK V2 in-circuit Debugger / Programmer for STM8 and STM32
ST-LINK V2 in-circuit Debugger / Programmer for STM8 and STM32
ST-LINK V2 in-circuit Debugger / Programmer for STM8 and STM32
  • Stock: In Stock
  • Model: PRO-3095
  • Weight: 0.05kg
Rs 384.00
(Excluding GST)

ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. To communicate with any STM8 or STM32 microcontroller located on an application board, the single-wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used.

Much similar in architecture for debugging, the ST-LINK/V2 and the ST-LINK/V2-ISOL share the same features like digital isolation between the PC and the target application board. It also withstands voltages of up to 1000 Vrms. STM8 applications use the USB full speed interface to communicate with ST Visual Develop (STVD) or ST Visual Program (STVP) software. STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments.

Features :

  • 5V power supplied by a USB connector
  • USB 2.0 full speed compatible interface
  • USB standard A to mini B cable
  • Direct firmware update feature supported
  • Status LED which blinks during communication with the PC
  • With cover case for protection, anti-dust and anti-short circuit
  • Dimension: 50mm x 28mm x 14mm

SWIM Specific Features:

  • 1.65 V to 5.5 V application voltage supported on SWIM interface
  • SWIM low-speed and high-speed modes supported
  • SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
  • SWIM cable for connection to the application via an ERNI standard vertical connector 
  • SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector

JTAG/serial wire debugging (SWD) specific features:

  • 1.65 V to 3.6 V application voltage supported on the JTAG/SWD interface and 5 V tolerant inputs
  • JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector
  • SWD and serial wire viewer (SWV) communication supported
  • Operating temperature : 0 to 50 °C
  • 1000 Vrms high isolation voltage (ST-LINK/V2-ISOL only)

Documents:

Package Includes :

  • 1 x ST-LINK/V2 debugging and programming Unit
  • 1 x USB standard A to mini B cable
  • 1 X FRC cable with 20 pin connector
  • 1 X Dual Female connectors 

Write a review

Please login or register to review