The Raspberry Pi Power over Ethernet HAT is a small accessory for the Raspberry Pi computer. It can only be used with the Raspberry Pi 3 Model B+.The PoE HAT allows to power Raspberry Pi using Power over Ethernet–enabled networks. For this product to be used, the network it is connected to, needs to have power-sourcing equipment installed. The HAT connects to the Raspberry Pi 3B+ 0.1” headers, the 40-way GPIO, and the new 4-pin header near the USB connectors, which allows to power the system using your Ethernet cable.
Power over Ethernet is a widely adopted standard that places power on the Ethernet cable along with the data. It has no effect on the data, so you won’t lose bandwidth by using PoE. There are various standards of PoE. This HAT uses the most common standard 802.3af, which allows delivery of up to 15W. This means that the HAT is capable of providing all the power needed for running your Raspberry Pi. You will need power sourcing equipment to power Pi. This is either provided by your network switch or with power injectors on an Ethernet cable.
The HAT is a compact, single-sided board that sits within the footprint of the Raspberry Pi. It will fit comfortably inside an official Raspberry Pi case. A small (25mm) fan is pre-installed on the board. We see the product as a useful component for people building systems that may be in tougher environments, so the addition of the fan helps with cooling. The fan is controlled over I2C via a small ATMEL processor which allows for it to be temperature-controlled when your Raspberry Pi processor hits certain temperatures, the fan will be turned on to cool it down. To enable this you will need to get the latest firmware (sudo rpi-update).Because the fan is controlled over I2C, none of the GPIO are used, so stack a second HAT on top of the connector.
Before installing the PoE HAT, attach the supplied spacers in the four corners of the board.Then connect the Raspberry Pi PoE HAT to the two 0.1” headers (40 + 4) that are fitted on the Raspberry Pi, Once the PoE HAT board is connected, power the Raspberry Pi through its RJ45 network connector. For to disconnect PoE HAT Pull evenly so that it detaches from all the pins at the same rate and do not pull one end of the connector off before the other.
No modification to the main Raspberry Pi board is needed for this product to work and to ensure that Raspberry Pi’s software is up to date for all functionality to be available. The PoE HAT is fitted with a small fan that is controlled by the Raspberry Pi via I2C.The fan will turn on and off automatically depending on the temperature of the main processor on the Raspberry Pi.Shall only be powered using 802.3af-compliant power sourcing equipment; any external power supply used with the Raspberry Pi shall comply with relevant regulations and standards applicable in the country of intended use
- Power over Ethernet (PoE) 802.3af Compliant
- Class 2 Device
- Fully Isolated Switched-Mode Power Supply (SMPS)
- Input Voltage: 36V – 56V
- Output Voltage: 5V
- Output Current: Up to 2.5A
- Integrated Fan Control and 25mm x 25mm Brushless Fan
- Plug-and-Play Compatibility with Raspberry Pi 3 Model B+
- 1X Raspberry Pi PoE HAT
- 1X RPi screws pack (4pcs)
There are currently no any reviews about this product.
There are currently no any question about this product.