Dual Channels Bidirectional Triac HAT for Raspberry Pi, Integrated MCU, Commands Control, UART / I2C. Integrates STM32F030 MCU, supports directly command control, easy for developping Quicker response, requires minimal resource from the Raspberry Pi Standard Raspberry Pi 40PIN GPIO header, customized for Raspberry Pi series boards
STM32F0 MCU controller, requires minimal Raspberry Pi resource, UART / I2C communication , RC snubber circuit, protect the triac from power fluctuation Up to 4400W output power, under ideal heat dissipation condition. Optocoupler isolation, preventing interference from the high voltage circuit. Indicator for easy checking the status of triac. Reserved UART and I2C interface, for working with other host control boards
Features:
- AC voltage： 100~600V
- AC current： 0~20A
- Dimensions：65 × 56.5(mm)
- Working voltage：3.3V/5V
- Interfaces：UART/I2C
- Controller：STM32F030
- UART data rate：1200 ~ 921600bps
- I2C data rate：≤1Mbps
Designed for Raspberry Pi series
Standard Raspberry Pi 40PIN GPIO header, customized for Raspberry Pi series boards
- STM32F0 MCU controller, requires minimal Raspberry Pi resource, UART / I2C communication
- RC snubber circuit, protect the triac from power fluctuation
- Up to 4400W output power, under ideal heat dissipation condition
- Optocoupler isolation, preventing interference from the high voltage circuit
- Indicator for easy checking the status of triac
- Reserved UART and I2C interface, for working with other host control boards
- Data rate: up to 921.6kbps for UART，up to 1024kbps for I2C
- Comes with development resources and manual (examples in C and Python
Powerful output power
Up to 4400W output power, under ideal heat dissipation condition
Optocoupler isolation
Optoisolated solution, preventing interference from the high voltage circuit
Home Appliance Support
In the example of controlling 220VAC Home Appliances
What's On Board
- BTA24-600 high power bidirectional triac
- MOC3021S photocoupler, the triac driver
- LTV-824S AC photocoupler
- RC snubber circuit
- LM358DR OP amplifier
- STM32F030F4P6 main controller
- RT9193-33PB power chip
- Output indicator
- 20A blow fuse
- Standard Raspberry Pi 40PIN GPIO header
- MCU control interface, for use with other host control boards like Arduino
- AC input
- AC output
- Data bus selection
- A: use Raspberry Pi I2C bus
- B: use Raspberry Pi UART bus
- Mode selection
- A: I2C mode
- B: UART mode
Pinout Definition
Package Includes:
- 1 x 2-CH TRIAC HAT
- 1 x Screws
Documents / Downloads:
Note: This is a relay device and the circuits are exposed. DO NOT touch the components onboard! We recommend you to add insulate enclosure when using. The device will get hot when working, higher the output power, hotter it is. The device will cut off output signal to protect the TRIAC when the temperate reaches 125°C. We recommend you to add cooling devices to let the TRIAC HAT work normally under 80°C.
There are currently no any reviews about this product.
There are currently no any question about this product.
