Description: This shield allows you to use a computer power supply (or other power source) to use your Arduino to switch high current. With RFP30N06LE MOSFETS, you can easily control a lot of current directly from your Arduino.
The board provides 6 PWM outputs via screw terminals. Check the datasheet for the MOSFET for full specifications on how much current this board can handle.This board is a very easy way to start using MOSFETS for your next high current project.
Note: If you want to stack another shield on top of this one, you will want to double-up on the stackable headers to clear the MOSFETs.
Package includes:
- 4 x 3-pin screw terminal
- 1 x IN4007 Rectifier Diode
- 1 x Yellow LED(5mm)
- 1 x Green LED(5mm)
- 2 x 8-in header
- 2 x 6- pin header
- 8 x 1K resistor
- 1 x Right angle ATX connector
- 6 x RFP30N06LE MOSFET
- 1 x Board
- 1 x Single DIP Switch
Documents:
There are currently no any reviews about this product.
There are currently no any question about this product.