-
USB 2.0 Full Speed compatible.
-
Compact High Quality Two layer PTH PCB
-
Professional EMI/RFI Complaint PCB Layout Design for Noise Reduction
-
On Board FT232R USB UART IC
-
Jumper selection for Interfacing Voltage Selection ( 3V3/5V)
-
Powered via USB
-
On Board Power LED Indicator
-
Supports data transfer from 300 Baud to 1 Mega Baud
-
Single chip USB to asynchronous serial data transfer interface.
-
Entire USB protocol handled on the chip. No USB specific firmware programming required.
-
Data transfer rates from 300 baud to 3 Mbaud (RS422, RS485, RS232 ) at TTL levels.
-
128 byte receive buffer and 256 byte transmit buffer utilising buffer smoothing technology to allow for high data throughput.
-
FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
-
Unique USB FTDIChip-ID™ feature.
-
Configurable CBUS I/O pins.
-
LEDs for Transmit and receive signals.
-
UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity
-
Synchronous and asynchronous bit bang interface options with RD# and WR# strobes.
-
Device supplied pre-programmed with unique USB serial number
-
Integrated level converter on UART and CBUS for interfacing to between +1.8V and +5V logic.
-
Configurable I/O pin output drive strength
-
UART signal inversion option.
-
Low operating and USB suspend current.
-
Low USB bandwidth consumption.
-
UHCI/OHCI/EHCI host controller compatible.
-
All I/O pin available at bergstrip
-
Internal EEPROM for device ID and Product Description strings
-
Royalty-Free Driver support for Windows, Linux, and Mac OSX
