1.3Inch Lcd Hat Printed Circuit Board is an IPS LCD display HAT for Raspberry Pi, 1.3inch diagonal, 240x240 pixels, with embedded controller, communicating via SPI interface.This LCD embedded ST7789VM, which is a controller for 24xRGBx320 resolution LCD. The resolution of this LCD is only 240(H)RGBx240(V) and supports initialize vertical display and horizontal display, thus the internal RAM of LCD is not full used. Most of LCD controller can be configured to 8080, 3-wire SPI, 4-wires SPI interface and so on. This LCD uses 4-wire SPI interface to save GPIO and faster communicating.
Features of 1.3Inch Lcd Hat Printed Circuit Board
- Standard Raspberry Pi connectivity, compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+
- IPS screen, wide viewing angle, better display
- High definition in small size
- 1x joystick, 3x pushbuttons, handy and useful
- Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)
- Driver: ST7789
- Interface: SPI
- Display color: RGB, 65K color
- Resolution: 240x240
- Backlight: LED
- Operating voltage: 3.3V
- 1 x 1.3inch LCD HAT
- 1 x RPi screws pack (2pcs)
There are currently no any reviews about this product.
There are currently no any question about this product.