This is a general LCD display Module, 1.8inch diagonal, 128x160 pixels, with embedded controller, communicating via SPI interface.
Features:
- SPI interface, requires minimum GPIO for controlling
- Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)
Specifications:
- Driver: ST7735S
- Interface: SPI
- Display color: RGB, 65K color
- Resolution: 128x160
- Backlight: LED
- Operating voltage: 3.3V
Interface:
- VCC: Power (3.3V input)
- GND: Ground
- DIN: SPI data input
- CLK: SPI clock input
- RST: Reset, low active
- CS: Chip selection, low active
- DC: Data/Command selection (high for data, low for command)
- BL: Backlight
Dimensions:

Package Includes:
- 1x 1.8 Inch LCD Module
- 1x PH2.0 20cm 8 pin
Documents/Downloads:
Note: The 0.96inch OLED consists of 1/4 yellow upper section and 3/4 blue lower section, not a regular dual-color display.
There are currently no any reviews about this product.
There are currently no any question about this product.