Description: Riding on the waves of the very popular Arduino USB board is this small prototyping shield. The ProtoShield mates with the Arduino USB board and gives the user a small soldering area, two general LEDs, access to a BlueSMiRF socket, a general pushbutton switch, and most important of all - the Arduino reset switch is brought to the top level. A ProtoShield quickstart guide is available!

This comes in kit form and must be soldered together by the end user.All soldering is through-hole (relatively easy) but always check your component orientation before soldering!

Note: The SparkFun ProtoShield Kit does not include the holes for the Uno R3 SDA and SCL.
Features:
All Arduino pins are brought to the top level
5V, GND, and Vin pins are exposed as well
BlueSMiRF socket for wireless communication between Arduinos
2 general use LEDs
1 general use button
Reset button brought to top level
Package Includes:
1 x ProtoShield bare PCB
2 x Stackable Headers 6-pin
2 x Stackable Headers 8-pin
2 x 5mm Basic Yellow LEDs
2 x 330 Ohm resistors
1 x 10k resistor
2 x Momentary push buttons
2 x 0.1uF Ceramic Capacitors
Documents & Downloads:
There are currently no any reviews about this product.
There are currently no any question about this product.