Arduino Mkr Iot Bundle (Original Kit From Arduino)

The MKR IoT Bundle using the Arduino MKR1000 for IoT applications. The MKR IoT bundle includes a selection of the most common and useful electronic components to build 5 IoT experiments. The kit is based around the MKR1000 a powerful board that combines the functionality of the Zero and the Wi-Fi Shield and enables Makers to add connectivity to their designs with minimal prior networking experience.

Note: Don't connect 9V to the board, as it will be damaged. You can use the 9v Battery strip to supply an external component.

Features of Arduino Mkr Iot Bundle

• MKR1000 combines the functionality of the Zero and the Wi-Fi Shield
• MKR1000 is based on the Atmel ATSAMW25 SoC
• Operating Voltage: 3.3V
• Arduino MKR1000 is able to run with or without the Li-Po battery

Package includes:

• 1 x Arduino MKR1000 board, with header soldered.
• 1 x micro USB cable,
• 1 x 400-point breadboard,
• 70x solid-core jumper wires, v
• 1 x 9V battery snap,
• 1 x stranded jumper wire
• 1 x stranded jumper wire,
• 6 x phototransistors,
• 3 x potentiometers (10 kilohm),
• 10x pushbuttons,
• 1 x temperature sensor (TMP36),
• 1 x tilt sensor,
• 1 x alphanumeric LCD (16 x 2 characters),
• 1 x bright white,
• 34 x LEDs (1 bright white, 1 RGB, 8 red, 8 green, 8 yellow, 3 blue),
• 1 x small DC motor (6/9V),
• 1 x small servo motor,
• 1 x piezo capsule (PKM17EPP-4001-B0),
• 1 x H-bridge motor driver (L293D),
• 1 x octocouplers (4NE5),
• 2 x MOSFET transistors (IRF520),
• 5 x capacitors (100uF),
• 5 x diodes (1N4007),
• 3 x transparent gels (R,G,B)
• 1 x male pin strip (40 x 1),
• 20 x resistors (220 ohm),
• 5 x resistors (560 ohm),
• 5 x resistors (1 kilohm),
• 5 x resistors (4.7 kilohm),
• 20 x resistors (10 kilohm),
• 5 x resistors (1 megohm),
• 5 x resistors (10 megohm)

Development resources

• Product page