128x160, General 1.8 Inch LCD Display Module - Waveshare

This is a general LCD display Module, 1.8inch diagonal, 128x160 pixels, with embedded controller, communicating via SPI interface.

Features:

• SPI interface, requires minimum GPIO for controlling
• Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)

Specifications:

• Driver: ST7735S
• Interface: SPI
• Display color: RGB, 65K color
• Resolution: 128x160
• Backlight: LED
• Operating voltage: 3.3V

Interface:

• VCC: Power (3.3V input)
• GND: Ground
• DIN: SPI data input
• CLK: SPI clock input
• RST: Reset, low active
• CS: Chip selection, low active
• DC: Data/Command selection (high for data, low for command)
• BL: Backlight

Dimensions:

Package Includes:

• 1x 1.8 Inch LCD Module
• 1x PH2.0 20cm 8 pin

Documents/Downloads:

• User Manual
• Schematic
• Datasheet  ST7735S
• Wiki (More Details) 

Note: The 0.96inch OLED consists of 1/4 yellow upper section and 3/4 blue lower section, not a regular dual-color display.