Description: This RFID Board is designed for reading the tag data from 125KHz compatible tags/cards. It reads EM4100 family transponder tags that are brought in proximity to the external antenna and outputs the unique tag identification number via TX pin or the Wiegand pins (as per SEL pin configuration). The 12 byte output includes ten bytes of actual tag's unique ID and checksum. Output format is totally compatible with that of EM-18 modules.
It works at a fixed factory set baud rate of 9600bps 8-N-1, which is supported by almost all microcontrollers & PCs. This RFID Reader Board can be connected directly to any TTL-compatible UART devices or to any any serial communication devices with right interfacing modules. With this super small design, it can be widely applied in office/home security, personal identification, access control, inventory control, payment systems, production control systems, etc.
NOTE: External antenna and the berg strip is soldered on to the board. If you need them without soldering, kindly mention the same in comments while placing the order.
||Output Pin: Wiegand DATA1
||Output Pin: Wiegand DATA0
||Power Supply Pin
||Output Pin: TTL Serial Data
||Selection Pin: Strap to VCC for TTL Serial, Strap to GND for Wiegand26
||Goes high on tag detection, Could be used with buzzer circuitry for audio alert
- Compact Design
- Bread Board compatible
- Professionally Designed Double sided FR-4 PTH PCB
- Very less decoding time
- Out format selection (TTL serial/Wiegand26)
- Supports external antenna, includes one
- Maximum Effective Distance Up To 15cm
- Reads EM4100 compatible tags/cards
- Standard 2.54mm Pitch Bergstrip connector
- Output pin (BUZ) that goes high on card detection
- Status LED for card detection
- On-Board Power LED
- Working Frequency: 125Khz
- Reading Distance: 10 ~ 15 cm
- Baud rate: 9600 bps (8-N-1)
- Interface: TTL and Wiegand26
- Power requirements: 4.5 to 5.5 VDC
- Antenna Inductance: 0.5mH
- Antenna Dimension: 28x28x3 (mm)
- PCB Dimension: 37x24x1.5 (mm)
- 1 x RFID Reader Board
- 1 x External Antenna Coil
There are currently no any question about this product.