Description: This LPG Gas Sensor Module is latest revision V2 ,which replaces the old module Part No: SEN-1327 .It is designed to enable LPG detection interface to Microcontroller without ADC Channels and programming. Apart from the trigger level setting Pot an extra Pot is also added in new version ,which allows to set the sensitivity of the sensor.
It allows to determine when a preset LPG gas level has been reached or exceeded. Interfacing with the sensor module is done through a 4-pin breadboard compatible SIP header and requires One I/O pin from the host microcontroller. The onboard microcontroller provide initial heating interval after powerup and then starts to meassure LPG sensor output.If it found the LPG concentration above setted value , it will inform the Host controller by pulling the Output Pin to High and Starts to blink a onboard status LED. The sensor module is mainly intended to provide a means of comparing LPG sources and being able to set an alarm limit when the source becomes excessive.
- Uses the MQ-6 LPG Gas Sensor
- Easy SIP interface
- Compatible with most microcontrollers
- Analog Sensor voltage is available at ANG pin.
- Onboard Status and Power LED
- Onboard Pot for threshold setting
- Onboard Pot for Sensitivity setting
- On board microcontroller
There are currently no any question about this product.