Reviews

Sort by: Recently  /  Helpful

Work great!

By Abhishek Srivastava from Uttar Pradesh, India on June 24, 2017
This product what's it suppose to do. Fits well in the raspberry pi GPIO pins.
Was this review helpful to you?   Yes   No

Nice Product

By Anitha Arora from New Delhi, India on June 06, 2017
Really good to use
Was this review helpful to you?   Yes   No

Useful product

By Vinayak Joshi from Goa, India on May 24, 2017
Delivers everything promised.
Advantages:
1)The switch provided helps to re-program the Arduino while the xbee is connected, this feature deserves applause.
2)Thanks to the extra long pin Female (male side extended)berge connectors the Arduino breakouts are mimiced perfectly on the shield.

Improvements
1) reset button for the xbee
2) digital and analogue pin breakouts pulled near the veroboard area (the digital pin breakout near the Arduino breakout is pointless)
3) disconnect the 2 hole and 3 hole Vero board holes connected on the bottom layer. Veroboard area should be connection less unless providing vcc or gnd.
4) This one is far fetched, but will earn Hugh applause. If possible have another switch which puts the Arduino I reset mode and connects the xbee to the usb to allow xctu (or any other xbee controlling computer program) to configure and use the xbee.
5) trim the xtra long male berge pins sticking out of the bottom of the shield such that the pins are not exposed when connected to the Arduino.
6) Xbee breakouts would be better suited outside the xbee area to allow interfacing of the xbee gpio using jumpers cables.
Was this review helpful to you?   Yes   No

Useful product

By Vinayak Joshi from Goa, India on May 24, 2017
The board delivers everything promised.

Possible improvements
1) Having an onboard reset would definitely be a boon.
2) The 2.54mm breakout would be better suited on the outside of the xbee. This would help in interfacing wires while resting the system on a workbench.

Issues
2 out of 3 boards that I purchased (well my client purchased for the project which I was working on) had the bottom silkscreened printed upside down. This caused a minor confusion, but was easily rectified.
Was this review helpful to you?   Yes   No

Cute

By M.Lakshmi from N/A on May 22, 2017
Module is nice, but Some times it is working when 5v and gnd is applied, in some cases it not exactly working [If 5v and gnd is applied and then switch on the power supply the D0 led is also on; actually power led will only on, D0 is on when touch/ vibrate then only D0 led will on ] what is the problem its manufactures problem or testing problem
2 of 2 people found this review helpful
Was this review helpful to you?   Yes   No