Servo Controller ( Usart & I2C) with ADC
- Stock: Out Of Stock
- Brand: rhydoLABZ
- Model: ROB-1185
- Weight: 0.04kg
Rs 1,190.00
(Excluding GST)
Description: The "Servo Controller ( Usart & I2C) with ADC" from Rhydolabz is a very compact solution for controlling up to eight RC servos from a PC or microcontroller. Each servo speed and range can be controlled independently. This servo controller supports I2C (TWI) and USART communications. The user could control the servomotors by sending the desired command from a USART or I2C (TWI) supporting device. Servo Controller supports two communication protocols Mini SSCII and RHYDO-SSC protocol. The built in 2 ADC Port can be used for measuring any analog voltage ( ie. 2 Sensor values) and the other ADC channel is permanently connected to measure Servo Voltage. With appropriate command from host controller the module will do ADC conversion for the selected channel and send out the result via I2C / USART. This feature is extremely useful for microcontroller without Onchip ADC ( like AT89S52), and to detect the battery low condition . Up to 128 Servos can be controlled by connecting 16 Module in Parallel.
Features:
Features:
- Compact High Quality Two layer PTH PCB
- Professional EMI/RFI Complaint PCB Layout Design for Noise Reduction
- Support Mini SSII and RHYDO-SSC Protocol
- I2C and USART interface with host Controller
- 3 Channel ADC measurement using command
- Servo volage measurement using command
- Onboard EEPROM to save Configuration Parameters
- Onboard RS232 to TTL conversion for PC based controlling
- On Board Status LED Indicator
- On Board TTL / RS232 / SPI connector
- Can set Neutral Point for each servo
- On Board EEPROM
- Mini SSII Mode in default and ready to use .
- Number of servo ports: 8 Nos
- Pulse Width Range: 0.25 to 2.75ms
- Resolution: (~0.05 degree)
- Supply voltage: 5 -16V
- I/O Voltage: 0-5 V
- Current consumption: 5 mA (average)
- Protocol supported: Mini SSII and RHYDO-SSC
- Interface Supported: I2C , USART(TTL), RS232
