The eCee AVRMega16 Development Board can be used to evaluate and demonstrate the capabilities of ATMEGA16 microcontroller. The board is designed for general purpose applications and includes a variety of hardware to exercise microcontroller peripherals. Ideally suitable for training and development purposes.
eCee AVRMega16 Features
Compact and Ready to use design
Professional EMI/RFI Complaint PCB Layout Design for Noise Reduction
High Quality Two layer PTH PCB
Includes AT MEGA16 Microcontroller
Board Supports AVR AT MEGA32AT MEGA8535 Microcontrollers
No separate programmer required (Built in Boot loader)
No Separate power adapter required (USB power source)
Screw terminal for External power Supply (with Jumper Select Option)
External Power Supply range of 7V to 20V
Adaptor (any standard 9-12V power supply) option
RS-232 Interface (For direct connection to PCs serial port)
On board Two Line LCD Display (2x16)
On board I2C EEPROM (4K-AT24C04)
On board I2C RTC (DS 1307) with Crystal and Battery
Four multiplexed 7-Segment LED Display
Built in Matrix keyboard (12 keys)
Built in Pull-Up (4 Keys) Keyboard
Built in IR Sensor Interface TSOP 1738
Built in 8 LED Interface to test I/O
On Board External Interrupt and Reset buttons
Built in Potentiometer interface to ADC
On Board Temperature Sensor Interface (LM35)
On Board Buzzer Interface
On Board PWM Output pin
On Board JTAG Connector for Debugging/Programming
On Board ISP Connector
On Board 16 MHz Crystal Oscillator
On Board Power LED Indicator
On Board DB9 Connector
On Board USB Connector
All Port Pins available at IDC (2x5) Connector
Can be used as main board for developing applications
Power Supply Reverse Polarity Protection
On Board 1 Amp Voltage Regulator
Demo HEX codes included for testing of board features
Example codes included
eCee AVRMega16 Package Includes
Fully Assembled and Tested eCee AVRMega16 Development board
Software CDROM with
Schematic
Programming Software
Sample Hex Code
Example Codes
AVR ATMega16 Chip Specification
Atmel AVR AT Mega16 with 16 MHz Crystal Oscillator (With Boot loader Software)
16 K bytes programmable flash
1 K bytes SRAM
512 bytes EEPROM
16 MHz operation (Up to 16 MIPS)
32 I/O pins
8 channel 10 bit ADC
4 PWM Channels
Two 8-Bit Timer/Counter
One 16-Bit Timer/Counter
One Serial USART
1 Two Wire Serial Interface TWI
SPI Master/ Slave
Power Consumption ~ 14 mA
Operating voltage
-- 2.7-5.5V for ATmega16L
-- 4.5-5.5 for ATmega16
Downloads:
User Manual
