USB to TTL ( 5V or 3V3) Converter

Price : USD 16.51  USD 12.90
Save: 22% off
(Tax excl.)
Part No: INT-1202
Availability : Out of stock
Weight: 0.04Kg
Made by: RHYDO

Quantity Discount Price
1USD 12.90
2-4USD 12.27
5-9USD 12.01
10+USD 11.61
Out of Stock

To be notified when this product is back in stock please click here.


USB <> TTL is a compact and ready to use board which performs USB to TTL (5V and 3V3) and vice versa conversion. The board holds an FT232R USB UART IC for  conversion. This module process an easiest interfacing of USB with microcontroller application boards. The unit is powered through USB and does not require external Power.The module Can be used for interfacing 5V and 3V3 application (ARM ect.) board to PC USB port.

USB to TTL Converter Features 
 • USB 2.0 Full Speed compatible.
 • Compact High Quality Two layer PTH PCB
 • Professional EMI/RFI Complaint PCB Layout Design for Noise Reduction
 • On Board FT232R USB UART IC
 • Powered via USB
 • On Board Power LED Indicator
 • Supports data transfer from 300 Baud to 1 Mega Baud
 • Single chip USB to asynchronous serial data transfer interface.
 • Entire USB protocol handled on the chip. No USB specific firmware programming required.
 • Data transfer rates from 300 baud to 3 Mbaud (RS422, RS485, RS232 ) at TTL levels.
 • 128 byte receive buffer and 256 byte transmit buffer utilising buffer smoothing technology to allow for high data            throughput.
 • FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver       development in most cases.
 • Unique USB FTDIChip-ID™ feature.
 • Configurable CBUS I/O pins.
 • LEDs for Transmit and receive signals.
 • UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity
 • Synchronous and asynchronous bit bang interface options with RD# and WR# strobes.
 • Device supplied pre-programmed with unique USB serial number
 • Jumper selection for Integrated +3.3V level converter I/O.
 • Integrated level converter on UART and CBUS for interfacing to between +1.8V and +5V logic.
 • Configurable I/O pin output drive strength
 • UART signal inversion option.
 • Low operating and USB suspend current.
 • Low USB bandwidth consumption.
 • UHCI/OHCI/EHCI host controller compatible.
 • All I/O pin available at bergstrip
 • Virtual COM port Driver be supplied.


Comments

by Akshay Nagarajan on 09/02/2010
Bought a couple of these from Rhydolabz, the delivery of the product was very quick. This module comes as a very handy interface for programming boards and computers, where the serial data can be easily read on the USB port and the FTDI driver available online can be used to make a very simple driver for the connected device.

Rating: 5 of 5 Stars [5 of 5 Stars]


 


Let us notify you when this product is back in stock!

Simply enter your details below and we will send you an e-mail when “USB to TTL ( 5V or 3V3) Converter” is back in stock!

We will not send you any other e-mails or add you to our newsletter, you will only be e-mailed about this product!





Your IP Address is: 54.81.75.69
Copyright © 2014 rhydoLABZ INDIA. Powered by rhydoLABZ
RHYDO