Header Board Features
• Easy to use DIP Package
• Includes NXP LPC 2129 Microcontroller
• On Board Power LED Indicator
• On Board JTAG Jumper
• On Board 10 MHz Crystal Oscillator
• On Board 32.768 KHz Crystal for RTC
• On Board 3.3V Regulator
• On Board 1.8V Regulator
• On Board Power Supply de-Coupling Capacitors
• All Port Pins available at Berge Strip
LPC 2129 Chip Specification
•NXP LPC 2129 with 10 MHz Crystal Oscillator (With Boot loader Software)
•High Performance 32-bit ARM7TDMI-S™ CPU
•256 KB Programmable Flash Memory provides a minimum of 100,000 erase/write cycles and 20 years of data retention.
•16 KB Data Memory (SRAM)
•In-System/In-Application Programming (ISP/IAP) via on-chip boot-loader software.
•Flash programming takes 1 ms per 512 byte line. Single sector or full chip erase takes 400ms.
•EmbeddedICE-RT interface enables breakpoints and watch points.
•Two interconnected CAN interfaces with advanced acceptance filters
•Four channel 10-bit A/D converter with conversion time as low as 2.44 us.
•Multiple serial interfaces including two UARTs , Fast I2C (400 kbits/s) and two SPIs
•60MHz maximum CPU clock available from programmable on-chip Phase-Locked Loop
•Vectored Interrupt Controller with configurable priorities
•Two 32-bit Timers.
•Four Capture and four Compare channels.
•PWM unit with six output pins.
•Real-time clock.
•Watch Dog Timer
•Up to forty-six 5V tolerant general purpose I/O pins.
•Up to nine edge or level sensitive external interrupt pins.
•On-chip crystal oscillator with an operating range of 1MHz to 30MHz.
•Two low power modes - Idle and Power-down.
•Processor wake-up from Power-down mode via external interrupt.
•Individual enable/disable of peripheral functions for power optimization.
•CPU operating voltage range of 1.65V to 1.95V and I/O power supply range of 3.0V to 3.6V
Downloads:
Quick start manual
