This is a breakout board using the AR1010 IC from Airoha. This FM receiver uses a simple command set over an I2C or SPI interface. Connect the OpAmp Breakout and a 3.5mm Audio Jack Breakout to the audio output pins and you will be able to plug in a 3.5mm audio cable to the OpAmp and listen to your favorite FM radio station! Check out the related items below. This Breakout board is from Sparkfun Electronics USA.
Note: An antenna is required. We've used a 31" piece of 22 gauge basic hook up wire with great results.
Features:
- 3.3V @ 11mA
- 76-108MHz supported
- 100mV audio output
- Stereo output
Documents:
