Hello!! Everyone.!!

I always face problem in uploading in ARM LPC2148 USB Development Board.

Can anyone tell me why it is so, am i doing some thing wrong..

I click on check button USE DTS/RTS

Selected Baud Rate of 9600 and Crystal Frequency of 60MHz

I reset the Board and After that Click on Read Device ID Button.

Then i release the Reset Button,

Some times it works and some times not.
What is the problem, please help

did you keep a jumper in the ISP slot after that you can press and release reset,then whenever
after that you try to upload program or read device ID you will get it ..