Description: These displays are small, only about 1.3" diagonal, but very readable due to the high contrast of an OLED display. This display is made of 132x64 individual white OLED pixels, each one is turned on or off by the controller chip. Because the display makes its own light, no backlight is required. This reduces the power required to run the OLED and is why the display has such high contrast; we really like this miniature display for its crispness!
The driver chip, SH1106 can communicate in two ways: I2C or SPI. The OLED itself require a 3.3V power supply and 3.3V logic levels for communication, but we include a 3.3V regulator and all pins are fully level shifted so you can use with 5V devices!
The power requirements depend a little on how much of the display is lit but on average the display uses about 40mA from the 3.3V supply. Built into the OLED driver is a simple switch-cap charge pump that turns 3.3v-5v into a high voltage drive for the OLEDs.
- Display Format: 132x64 Dots
- Interface: 6800 8-bit Parallel , 8080 8-bit Parallel , I2C, 3-Wire Serial SPI, 4-Wire Serial SPI
- IC or Equivalent: SH1106
- Diagonal Size: 1.3“
- Operating Temperature: -40℃~70℃
- Voltage: 3V ~ 5V DC
- Simple command sets, easy to remember
- Simple graphic engine integrated
- 1x 1.3" Serial OLED Display Module
There are currently no any reviews about this product.
There are currently no any question about this product.