Description: Riding on the waves of the very popular Arduino USB board is this small prototyping shield. The ProtoShield mates with the Arduino USB board and gives the user a small soldering area, two general LEDs, access to a BlueSMiRF socket, a general pushbutton switch, and most important of all - the Arduino reset switch is brought to the top level. A ProtoShield quickstart guide is available!
This comes in kit form and must be soldered together by the end user.All soldering is through-hole (relatively easy) but always check your component orientation before soldering!
Note: The SparkFun ProtoShield Kit does not include the holes for the Uno R3 SDA and SCL.
All Arduino pins are brought to the top level
5V, GND, and Vin pins are exposed as well
BlueSMiRF socket for wireless communication between Arduinos
2 general use LEDs
1 general use button
Reset button brought to top level
1 x ProtoShield bare PCB
2 x Stackable Headers 6-pin
2 x Stackable Headers 8-pin
2 x 5mm Basic Yellow LEDs
2 x 330 Ohm resistors
1 x 10k resistor
2 x Momentary push buttons
2 x 0.1uF Ceramic Capacitors
Documents & Downloads:
There are currently no any reviews about this product.
There are currently no any question about this product.