Description: The Danger Shield mounts on top of your Arduino or Arduino Pro and equips it with a variety of fun and useful inputs and outputs. The Danger Shield has so much potential; we can't wait to see what you're able to do with it!
The shield's features include:
Three linear slide potentiometers connected to the Arduino's analog pins 0 through 2.
Red and yellow LEDs connected to digital pins 5 and 6 - PWM pins - so you can easily vary their brightness.
Three momentary push buttons connected up to the Arduino's digital pins 10 through 12. Those lines will go low when the buttons are pressed.
A photocell and a temperature sensor, both with analog outputs, are connected to the analog pins 3 and 4, respectively.
An 8-bit shift register set up to control a blue 7-segment LED.
Two buzzers - one is used, as you'd expect, as a speaker, the other is connected to analog pin 5 and can be used as a knock sensor.
This new version uses a different temperature sensor. This product comes as a kit of parts, which you'll have to solder into the included PCB. All parts are through-hole so it should go together relatively easily; but always check your component orientation before soldering!
1 x PCB Danger Shield Kit
3 x Slide Potentiometers - 10K
1 x 7-Segment LED - Blue
1 x 8-bit Shift Register - 74HC595
1 x Temperature Sensor - TMP36
1 x Miniature Photocell
2 x Buzzers
1 x Basic LED - Red
2 x Basic LEDs - Yellow
1 x Mini Push Button
3 x Momentary Push Buttons - 12mm Square
11 x Resistors - 330 Ohm
4 x Resistors - 10K Ohm
1 x Resistor 1M Ohm 1/6W
2 x 8-pin Arduino Stackable Headers
2 x 6-pin Arduino Stackable Headers
Documents & Downloads:
There are currently no any reviews about this product.
There are currently no any question about this product.